Service & Maintenance

Sprinkler System Service & Maintenance

Spring Start-up

  • Inspect water connection, blow out point and backflow device
  • Close test ports on backflow
  • Turn on water and pressurize system
  • Test operation
  • Inspect and adjust sprinkler heads
  • Test rain sensor
  • Check and clean drip filters (if appropriate)
  • Program controller

Winterization

  • Turn off water supply
  • Connect our air compressor to the blowout point
  • Blow out each zone for at least 2 minutes
  • Repeat this process for each zone
  • Open test ports on backflow deviceTurn off controller

Seasonal Adjustments

  • Inspect water connection, blow out point and backflow device
  • Test operation
  • Inspect and adjust sprinkler heads
  • Test rain sensor
  • Re-program controller
irrigation